GCK series Low voltage switchgear
General:GCK series Low voltage switchgear(hereinafter short as switchgear)is a com…
GCK series Low voltage switchgear

GCK series Low voltage switchgear

Detailed description

  • Description
  • Technical data

General:
GCK series Low voltage switchgear(hereinafter short as switchgear)is a complete power distribution device for 3.6~24kV,3-phase AC 50Hz,single-bus and single-bus sectionalized system. It is mainly used for power transmission of middle/small generators in power plants; power receiving, transmission for substations in power distribution and power system of factories, mines and enterprises, and starting of large high-voltage motor, etc.,so as to control, protect and monitor the system. The switchgear meets IEC298,GB3906-91.In addition to be used with domestic VS1 vacuum circuit breaker, it can also be used with VD4 from ABB,3AH5 from Siemens

domestic ZN65A,and VB2 from GE, etc.,it is truly a power distribution device with good performance. In order to meet the requirement for wall mounting and front-end maintenance, the switchgear is equipped with a special current transformer, so that the operator can maintain and inspect it in front of the cubicle.

Service environment:
a) Air temperature: Maximum temperature: +40°C; Minimum temperature:-15°C

b) Humidity: Monthly average humidity 95%; Daily average humidity 90% .

c) Altitude above sea level: Maximum installation altitude: 1000M.

d) Ambient air not apparently polluted by corrosive and flammable gas, vapor etc.

e) No frequent violent shake

Protection grade

1P40

Rated working voltage

AC, 380(V)

Frequency

50Hz

Rated insulation voltage

660V

Working conditions

Environment

Indoors

Altitude

≤2000m

Ambient temperature

-5~+ 40

The min temperature under store and transportation

-30

Relative hunidity

≤90%

Capacity of control motor(kW)

0.4~155

Best solution for your power!
Copyright © 2018 Rockwill Electric Group Co.,Ltd. All Rights Reserved.