News: No.5: Rockwill's SF6 gas insulated LBS passed the KEMA test! No.4. Signed ACR and LBS KEMA type test at 2019 No.3. Cherish life,Pls stay in safe and far away from Covid-19 No.2: Rockwill's pole mounted load break switch passed the KEMA type test!
completely self protected transformer
Summary SCP series fully automatic protection pole mounted transformer, the trans…
completely self protected transformer

completely self protected transformer

Detailed description

  • Description
  • CSP Technology

Summary

SCP series fully automatic protection pole mounted transformer, the transformer refers to pole-mounted transformer high side and low-side configuration with some protection components, so as to protect the transformer and network security. Fully automatic single-phase transformer on lightning protection, short-circuit and overload protection can play its own role, to protect the transmission and distribution lines not because of their own transformer failure caused by power outages.




Operating Environment


(1) Below an altitude of 2000m

(2) Ambient temperature: Max. temperature is +40℃ and the min. temperature is -25℃

(3) Outdoor wind speed shall not exceed 35m/s

(4) Pollution grade: Class II

(5) Earthquake horizontal acceleration is not greater than 3m/s2, the vertical acceleration is not greater than 1.5m/ s2, and the safety factor is more than 1.67.




CSP Technology

Rockwell equipped several components, in order to create the CSP transformer.These components when applied to the transformer during its manufacturing process, provide multiple layers of protection.



Outline drawing High Voltage Fuse







Acts as over current protection by isolating the faulty transformer from the network. It is mounted inside of the transformer and it is connected between the incoming high voltage lead from the bushing and the high voltage line lead from the transformer primary winding.


Overload Indicator

Provides visual indication of abnormal loading conditions. The signal light is mounted on the exterior wall of the transformer tank near the operating handle of the circuit breaker. The signal light is electrically connected to the signal light sensing circuit within the transformer.




Low Voltage (Secondary) Circuit Breaker

Provides secondary fault and overload protection. The circuit breaker is mounted inside of the transformer and it is connected between the secondary winding and secondary bushing, such that the current flows through the circuit breaker


Three phase Low Voltage Circuit Breaker                                                  Single phase Low Voltage Circuit Breaker




About Us
Success References
Best solution for your power!
Copyright © 2018 Rockwill Electric Group Co.,Ltd. All Rights Reserved.